Engine - GM (19433063)
19433063
Engine - GM (19433063)
19433063
- GM
- 19433063
- 12682080, 19370671, 19418256
Details
- Brand:
- SKU:
19433063
- Description:
E-ROD SYSTEMS HAVE IT ALL
Each E-ROD crate engine system carries an official California Air Resources Board (CARB) E.O. number and includes complete emissions equipment, along with the engine controller and harness needed to get the engine running. The primary elements of each kit include:- Chevrolet Performance crate engine
- Engine control module
- Exhaust manifolds
- Catalytic converters
- Mass airflow sensor and sensor boss
- Oxygen sensors and sensor bosses
- Air filter
- Accelerator pedal
- Evaporative emissions canister
- Instruction manual
- CARB EO#: (PENDING)
- Horsepower: 455 @ 6,000 rpm
- Torque: 465 lb.-ft. @ 4,600 rpm
INSTALLATION NOTES
Engines shipped with high-pressure direct-injection fuel pump installed
Assembly does not include any electronics
Kit includes electronic throttle pedal, which is required for throttle input to the ECU
Intended for pre-1995 street vehicles or any off-road vehicle
Not intended for marine applications
Front-End Accessory Drive Kit can be ordered separately
8-bolt crankshaft flange
Shipped with 14" flexplate
BUILDER'S NOTE
To facilitate a complete E-ROD installation, the builder will need to source additional components to complete the assembly and get the vehicle running, including:- Fuel tank
- Fuel lines (re-circulating or returnless)
- Fuel pump - 58 psi (400 kPa) for LC9 and LS3 or 65 psi (450 kPa) for LSA
- Fuel tank vent line from the tank to the evaporative emissions canister
- Purge line from the canister to the engine purge solenoid
- Air induction system that incorporates the mass airflow sensor
- Exhaust system behind the catalytic converters.
Chevrolet Performance recommends the LS1 Engine Installation Guide P/N 88959384, which illustrates basic procedures and offers helpful tips on installing an LS engine into older vehicles.
E-ROD systems do not come with a transmission. Chevrolet Performance recommends the SuperMatic(TM) 4L70-E - P/N 19244043 - four-speed automatic overdrive transmission, along with Chevrolet Performance's SuperMatic(TM) transmission controller P/N 19257634, for LC9 and LS3 systems. The LSA, with higher torque output, should use the SuperMatic(TM) 4L85-E, P/N 19300175, along with the SuperMatic(TM) transmission controller, P/N 19302410.
*GM automatic transmissions are typically equipped with 40-tooth reluctor wheels for vehicle speed sensor output. GM late-model manual transmissions are typically equipped with a 17-tooth reluctor wheel. The Chevrolet Performance T56 Super Magnum six-speed manual (P/N 19329795) is equipped with a 40-tooth reluctor wheel.
You May Also Like
Bell Housing Kit LS and LT Engines
$860.52
Clutch Kit LS/LT Engines (8-Bolt Crank)
$1,714.42
LT1 Aluminum Automatic Bell Housing
$176.90 - Replaces:
12682080, 19370671, 19418256
- MSRP: $16,085.98
- Discount: $2,595.24 (16.1% off)
- Sale Price: $13,490.74
- GM
- 19433063
- 12682080, 19370671, 19418256
Details
- Brand:
- SKU:
19433063
- Description:
E-ROD SYSTEMS HAVE IT ALL
Each E-ROD crate engine system carries an official California Air Resources Board (CARB) E.O. number and includes complete emissions equipment, along with the engine controller and harness needed to get the engine running. The primary elements of each kit include:- Chevrolet Performance crate engine
- Engine control module
- Exhaust manifolds
- Catalytic converters
- Mass airflow sensor and sensor boss
- Oxygen sensors and sensor bosses
- Air filter
- Accelerator pedal
- Evaporative emissions canister
- Instruction manual
- CARB EO#: (PENDING)
- Horsepower: 455 @ 6,000 rpm
- Torque: 465 lb.-ft. @ 4,600 rpm
INSTALLATION NOTES
Engines shipped with high-pressure direct-injection fuel pump installed
Assembly does not include any electronics
Kit includes electronic throttle pedal, which is required for throttle input to the ECU
Intended for pre-1995 street vehicles or any off-road vehicle
Not intended for marine applications
Front-End Accessory Drive Kit can be ordered separately
8-bolt crankshaft flange
Shipped with 14" flexplate
BUILDER'S NOTE
To facilitate a complete E-ROD installation, the builder will need to source additional components to complete the assembly and get the vehicle running, including:- Fuel tank
- Fuel lines (re-circulating or returnless)
- Fuel pump - 58 psi (400 kPa) for LC9 and LS3 or 65 psi (450 kPa) for LSA
- Fuel tank vent line from the tank to the evaporative emissions canister
- Purge line from the canister to the engine purge solenoid
- Air induction system that incorporates the mass airflow sensor
- Exhaust system behind the catalytic converters.
Chevrolet Performance recommends the LS1 Engine Installation Guide P/N 88959384, which illustrates basic procedures and offers helpful tips on installing an LS engine into older vehicles.
E-ROD systems do not come with a transmission. Chevrolet Performance recommends the SuperMatic(TM) 4L70-E - P/N 19244043 - four-speed automatic overdrive transmission, along with Chevrolet Performance's SuperMatic(TM) transmission controller P/N 19257634, for LC9 and LS3 systems. The LSA, with higher torque output, should use the SuperMatic(TM) 4L85-E, P/N 19300175, along with the SuperMatic(TM) transmission controller, P/N 19302410.
*GM automatic transmissions are typically equipped with 40-tooth reluctor wheels for vehicle speed sensor output. GM late-model manual transmissions are typically equipped with a 17-tooth reluctor wheel. The Chevrolet Performance T56 Super Magnum six-speed manual (P/N 19329795) is equipped with a 40-tooth reluctor wheel.
You May Also Like
Bell Housing Kit LS and LT Engines
$860.52
Clutch Kit LS/LT Engines (8-Bolt Crank)
$1,714.42
LT1 Aluminum Automatic Bell Housing
$176.90 - Replaces:
12682080, 19370671, 19418256
Engine - GM (19433063)
19433063
Also Purchased
Vehicle Fitment
| Year | Make | Model | Body & Trim | Engine & Transmission |
|---|
Details
- Brand:
- SKU:
19433063
- Description:
E-ROD SYSTEMS HAVE IT ALL
Each E-ROD crate engine system carries an official California Air Resources Board (CARB) E.O. number and includes complete emissions equipment, along with the engine controller and harness needed to get the engine running. The primary elements of each kit include:- Chevrolet Performance crate engine
- Engine control module
- Exhaust manifolds
- Catalytic converters
- Mass airflow sensor and sensor boss
- Oxygen sensors and sensor bosses
- Air filter
- Accelerator pedal
- Evaporative emissions canister
- Instruction manual
- CARB EO#: (PENDING)
- Horsepower: 455 @ 6,000 rpm
- Torque: 465 lb.-ft. @ 4,600 rpm
INSTALLATION NOTES
Engines shipped with high-pressure direct-injection fuel pump installed
Assembly does not include any electronics
Kit includes electronic throttle pedal, which is required for throttle input to the ECU
Intended for pre-1995 street vehicles or any off-road vehicle
Not intended for marine applications
Front-End Accessory Drive Kit can be ordered separately
8-bolt crankshaft flange
Shipped with 14" flexplate
BUILDER'S NOTE
To facilitate a complete E-ROD installation, the builder will need to source additional components to complete the assembly and get the vehicle running, including:- Fuel tank
- Fuel lines (re-circulating or returnless)
- Fuel pump - 58 psi (400 kPa) for LC9 and LS3 or 65 psi (450 kPa) for LSA
- Fuel tank vent line from the tank to the evaporative emissions canister
- Purge line from the canister to the engine purge solenoid
- Air induction system that incorporates the mass airflow sensor
- Exhaust system behind the catalytic converters.
Chevrolet Performance recommends the LS1 Engine Installation Guide P/N 88959384, which illustrates basic procedures and offers helpful tips on installing an LS engine into older vehicles.
E-ROD systems do not come with a transmission. Chevrolet Performance recommends the SuperMatic(TM) 4L70-E - P/N 19244043 - four-speed automatic overdrive transmission, along with Chevrolet Performance's SuperMatic(TM) transmission controller P/N 19257634, for LC9 and LS3 systems. The LSA, with higher torque output, should use the SuperMatic(TM) 4L85-E, P/N 19300175, along with the SuperMatic(TM) transmission controller, P/N 19302410.
*GM automatic transmissions are typically equipped with 40-tooth reluctor wheels for vehicle speed sensor output. GM late-model manual transmissions are typically equipped with a 17-tooth reluctor wheel. The Chevrolet Performance T56 Super Magnum six-speed manual (P/N 19329795) is equipped with a 40-tooth reluctor wheel.
You May Also Like
Bell Housing Kit LS and LT Engines
$860.52
Clutch Kit LS/LT Engines (8-Bolt Crank)
$1,714.42
LT1 Aluminum Automatic Bell Housing
$176.90 - Replaces:
12682080, 19370671, 19418256
GM PARTS ONLINE
When it comes to serving our customers, our staff has over 250 years of combined GM parts experience to serve you. Whether you’re looking for a part for your new GM vehicle or a part for a discontinued brand like Pontiac or Saturn, we’ve got the expertise to find the part and get it ready to ship. If you purchase your (19433063) from us, you are guaranteed to receive a genuine OEM part designed and manufactured by GM to fit your specific vehicle. All of our parts and accessories are backed by GM's Part Warranty. If you have a question, a problem, or just need help looking up a part, please Contact Us and we will be happy to help.
If you need more parts, select the brand you are shopping for below:
GM
GM is one of the leaders when it comes to cranking out quality made cars, trucks and SUVs. None of that changes when it comes to OEM parts and accessories on GM Parts Online. Keep you car running GM new with OEM affordable parts and accessories with GM Parts Online.

